270 Degree Right and 90 Degree Left HDMI adapter

The STC Angled HDMI Adapters avoid bending HDMI cables and relief the strain on HDMI ports to protect your cable and device.

Specifications
- Connector 1: HDMI (Type A) Male
- Connector 2: HDMI (Type A) Female
- Supports resolutions at 4096 2160, 3840 2160, 2560 1600, 2560 1440, 1920 1200, 1080p and etc
- Supports uncompressed digital 7.1, 5.1 or 2 channels audio
- Supports 3D and Ethernet

Package Contents
1x Flat 90 Degree HDMI Adapter
1x Flat 270 Degree HDMI Adapter

Warranty
2-Years Warranty and Product Support



Customer Feedback



"I needed this for my entertainment stand to plug in an HDMI cable into a switch, where the 5th port stuck out to the side. I needed space, and couldn't have part of a cord jutting out to the side, and I am not a fan of cords being trained with sharp bends, especially near the connectors, so this product worked great in that regard.

I do wish, however, that the construction seems a bit big. That is, the "casing" of the "L" joint seems rather big for the functionality. If I had to use this in a setup where, for example, multiple HDMI ports were lined up horizontally, I am a bit worried that the size of the casing would essentially cut off access to HDMI ports on either side of the series.

That being said, for my purpose of the lone HDMI port on the side of my switch, this was not a concern and works perfectly for my needs."



"Works great for my notebook when it's on my desk. now the cord goes straight back along the side of the notebook and as out of the way as possible. the second one might come in handy for a Roku or Chromecast or PC Stick computer though. signal quality looks perfect, as far as i can tell."



"I used this on a lap top in a computer desk. I wanted the left side up against a wall, but with the HDMI cable coming straight out, it took up 5 inches. Now I can slide the lap top up to this connector, and it only uses 1 inch of space, the HDMI cable can head straight back toward the back of the cabinet and out the hole and up to the large monitor. Works great."



"the combo of opposing directions on these heads worked great, since my wall mounted TV (like many) has a lot going on near the data ports and you need every direction to get your cables away from the TV. the benefit of the angled heads is that the HDMI cables can lay along the direction of the TV as opposed to away from it, preventing them from pushing the TV away from the wall with telescoping mounts."



"These are great to take the strain off the horizontal HDMI connectors on my TV sets. The TVs connect to the cable boxes on the shelves below the TVs in my living room and bedroom. I was lucky that one of the TVs had the HDMI connector on the left side of the TV and on the right side of the other TV. Worked perfect."