AAK hydraulic flow control valves were still normal after being used for 15 mont

Miguel is from a hydraulic equipment company in Brazil. He began to purchase hydraulic components in China 3 years ago, and it was successful. At the beginning of last year, the hydraulic flow control valves he purchased encountered problem and almost suffered a claim. Since using AAK hydraulic flow control valves to replace, he knows that there are also hydraulic valve manufacturers in China that have benchmarked the quality of German manufacturers.

Miguel company sold a hydraulic unit, which was used in wind power generation equipment near the sea. Half a year later, the customer complained that the valve body of the hydraulic flow control valve was seriously corroded and stuck, leading to the strike of the wind turbine generator. According to the factory feedback of the original hydraulic flow control valves, the corrosion of the valve body is caused by the objective marine climate, the hydraulic flow control valves can only be replaced. Miguel realized that replacing it within 6 months was not only expensive for after-sales, but also not necessarily acceptable to the customer. He purchased the hydraulic flow control valves from Germany to replace it. At the same time, he asked some new hydraulic valve manufacturers to make samples and required that the hydraulic flow control valves to be guaranteed for 12 months or more in the corrosive environment near the sea. Most manufacturers gave up, and only two were willing to test samples, including AAK.

After 40 days, AAK shipped the trial order of 30 hydraulic flow control valves. There has been no email from Miguel since the trial order was delivered. 15 months later, that is, last week, Miguel suddenly emailed us to purchase 800 hydraulic flow control valves. After communication, we learned that they were very satisfied with AAK hydraulic flow control valve samples delivered 1 year ago. The samples from another factory were corroded in 10 months, while AAK's were still fine after 15 months. This service life was benchmarked to the hydraulic flow control valves purchased from German manufacturers, but the price of AAK was 30% cheaper, so they directly placed a big order.

AAK hydraulic flow control valves can be used in highly corrosive marine environment for 15 months without damage. The key lies in 3 points, which most domestic hydraulic valve manufacturers cannot do:

1. In terms of material, 3Cr3Mo3W2V hot working die steel is selected for the valve body, and its mechanical stress is optimized by at least 50% compared with other steels. After personalized heat treatment, the hardness, strength and corrosion resistance of the material are more than doubled.

2. In terms of surface treatment, zinc nickel alloy coating is adopted, and the corrosion resistance of the valve body is improved again. Its corrosion resistance is more than 10 times higher than that of ordinary zinc plating and nickel plating processes, which can ensure that there is no red rust after neutral salt spray test for more than 1500 hours.